The fuel surge tank can be mounted near the main fuel tank or in the engine bay. Mounting locations near heat sources or moving parts such as suspension components should be avoided. It should also be mounted away from common collision areas.
Floor and Wall Mount - This bracket is laser cut from aluminum and powder coated black and can be mounted on the side or bottom of the surge tank.
Frame Mount - Because this bracket has a 90deg formed bend and is cantilevered, it is constructed from steel for superior strength. It is not only nickel plated to resist corrosion, it also allows for components to be grounded to the spare hole in the bracket. This assumes the bracket is mounted to an electrically conductive material such as a steel frame.
Angled Mount - This mounting bracket is used for vehicles that may have a limited mounting height. It can be mounted on a floor and against a wall. This bracket is made from laser cut aluminum and powder coated black.
CONVERSION KIT FOR WALBRO F90000262 GAS AND F90000267 E85 PUMPS
This kit enables a Radium FST to be converted to use a single Walbro F90000262 Gas or Walbro F90000267 E85 fuel pump. This kit is only compatible when the original FST used one of the following pumps: Walbro GSS342 255lph, AEM 50-1000 Gas, AEM 50-1200 E85, Aeromotive 11142 or a Deatschwerks 9-301-1000. The following parts will be reused: billet FST canister, billet FST top cap, three -6AN port fittings, -6AN bulkhead nut, 16 perimeter M5 bolts, 2 internal M5 bolts, external wiring harness, external mounting bracket and hardware
- Walbro 400 specific Billet Aluminum Bottom Cap
- Walbro 400 specific Laser Cut Mounting Bracket
- Internal Bulkhead Wiring for Walbro (specify which pump)
- Billet Aluminum Bulkhead Fitting with O-ring
- Submersible Rubber Fuel Hose
- Stainless Steel Pinch Clamp, Factory Crimped
- Stainless Steel EFI Protective Clamp
- Replacement FST Perimeter O-rings (x16)
- Replacement FST Large O-rings (x2)