Home > FOCUS ST > INDUCTION > METHANOL & WATER SYSTEMS >

AEM V2 2013-14 Ford Focus ST 1 Gallon Water/Methanol Injection Kit

AEM V2 2013-14 Ford Focus ST 1 Gallon Water/Methanol Injection Kit


 
List Price: $609.09
Our Price: $459.00
Savings: $150.09

Availability:: Usually Ships in 24 Hours
Product Code: 30-3300
Qty:

Description Technical Specs Full Product Description
 

AEM V2 2013-14 Ford Focus ST 1 Gallon Water/Methanol Injection Kit

Water/methanol injection for gas engines is a proven means for effectively reducing engine inlet air temperatures and suppressing harmful detonation on forced induction and high performance naturally aspirated race engines. This allows racers to reliably increase boost and advance ignition timing—without using high-octane racing fuel—for power gains of up to 20%. AEM’s Water/Methanol Injection Systems utilize the most robust hardware combined with more advanced features than any other comparably priced water/methanol system.

The on-demand progressive controller in AEM’s Boost Dependent PN30-3300 Water/Methanol Injection kit bases injection flow on manifold pressure using an on-board MAP sensor (up to 35 PSI of boost) to ensure the proper amount of water/methanol injection at all points along an engine’s power curve.

Features
    • Boost Dependent controller features on-board MAP sensor with large adjustment knobs, integrated plug for harness connection, integrated fuse, covered status light and test button for enhanced splash resistance and mounting tabs
    • Wiring harness is terminated with a positive-lock connector on one end with color-coded wires to ease installation, power and ground wires for the pump and additional wire for optional on/off fluid solenoid
    • “Boost Safe” failsafe output included (for complete failsafe under all conditions, seeWater/Methanol Failsafe Device)
    • Internally-bypassed water/methanol injection pump does not cycle on an off and provides quiet, smooth operation. It features robust construction including integral hose fittings, EPDM seals and a Santoprene diaphragm that provides consistent and reliable fluid delivery
    • Precision-machined billet-aluminum injector with integral check valve
    • Three interchangeable injector nozzles to cover a wide variety of HP levels (250cc/min, 500 cc/min & 1,000cc/min)
    • 1 gallon tank(10" x 8.5" x 4.25") with integral conductive low-fluid sensor and positive lock connector (tank-less water/methanol gas systems available, AEM Part #30-3302 includes controller with on-board 35 PSI MAP sensor)
    • 20 feet of Nylon injection tubing included
    • LED dash light for system status and low fluid warning

Share your knowledge of this product. Be the first to write a review »

Browse for more products in the same category as this item:

FOCUS ST > INDUCTION > METHANOL & WATER SYSTEMS
FOCUS ST > INDUCTION